I have recieved a little feedback and suggestions from several people on Rctech and in email. Here is a run down so far.
- One suggestion was to include some thin orings to take up the gap between the clip and the strap if a thinner lipo pack is used. I certainly may be doing this soon.
- Sand and glue the edges, makes the product look even better and strengthens carbon laminate.
- Ream out the holes for the posts on both ends just a little so the straps can be removed a little easier. It also helps to bevel the edges a little.
- The balance port may need to be enlarged a little depending on where this is located. I think I will make an adjustment in the design and start making this hole a little bigger.